iFlight Blitz Whoop F7 55A AIO V1.1
This is the iFlight BLITZ series AIO FCs for your ultimate build. A future-proof all-in-one FC to step up the game and make some more room for future flight firmware development like Betaflight, Emuflight, etc. Lightweight, minimum size, minimum work. This could only be achieved by using BGA chipsets instead of ordinary QFP (big size) MCUs and ultra-powerful Mosfets for almost any build. Solder your motor wires on and let's go!
Features:
- Separated Flight Control board to minimize electrical gyro noise
- Pass-through DJI O3 and Caddx Vista/Polar Connector
- FC PCB can be disassembled from the ESC PCB; Repair allowed!
- MCU: BGA-STM32F745, 216MHz
- OSD: AT7456E
- Blackbox: 16MB Onboard Flash
- Gyro: BMI270
Specifications:
FLIGHT CONTROLLER
- MCU: BGA-STM32F745
- Gyro: BMI270
- Blackbox: 16MB Onboard Flash
- BEC output: 5V 2.5A
- WS2812 LED Strip: Yes
- Buzzer: Yes
- Barometer: DPS310
- Connector: Micro-USB
- OSD: IFLIGHT OSD (AT745E）
- FC Firmware：IFLIGHT_BLITZ_F7_AIO
- Mounting pattern: 25.5*25.5mm φ3mm
- Dimensions: 35*35mm
- Weight: 10.5g
- BEC: 5V 2A / 3A
- Input voltage: 2-6S, support LIHV battery
- Smartaudio / IRC Tramp VTX protocol supported
ESC
- ESC MCU: BB21
- Driver: FD6288
- Input voltage: 2-6S Support LIHV battery
- Output current: 55A, peak value 65A (10 seconds)
- ESC firmware: Q-H-40 - Bluejay, 0.16, 24kHz
- Current sensor: ratio 200 (1/10mV/A)
- BEC: NO
- ESC Telemetry: NO
- Bidirectional DShot: Yes(need to use Bluejay firmware)
- Supports DShot DShot150/300/600/MultiShot/ OneShot etc.
Includes:
1x iFlight Blitz Whoop F7 55A AIO V1.1
2x Capacitor 470uF/35V
1x XT30 Male 18AWG Cable 70mm
1x 1.0-7P cable 50mm-28mm
1x 1.0-7P cable 50mm
4x M2 silicon grommets
8x M2*12mm Screws
8x M2 Transparent Nylon Nut
10x 0.8mm black Heat Shrink Tube 10mm
