The Skystars RC F722 Mini HD Pro is a 20x20 flight controller with a powerful F7 processor, 6 UARTs, dual 5v and 10V BEC, barometer, built-in blackbox, and more. All this fits on a small board measuring just 35x28mm and weighing only 4.8g.
- Solder pads are the largest in size compared to other similar sized FC in market.
- Proper solder pad spacing to avoid solder bridge and facilitate easy soldering.
- ESC connector on top-side rather than bottom which makes it easy for repair.
- Hybrid design allows both M3 and M2 screws.
- TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression.
- Powerful BEC to supply all your electronics.
- Pads arrangement are executed in such a way that when you twist the wires of the camera VTX and RX you don’t get any wire overlapping this gives you a uniform twist and clean look.
- DJI connector on the bottom side.
- Budget-friendly price ( We understand the situation of chip shortage and rising prices of FC )
- Two stages of Quality check to reduce any faulty electronic.
- No power lines near Gyro to avoid any EMI interference.
- Comes ready with I2C support and INAV.
- Item name: F405Mini HD2 Betaflight Flight Controller
- Input voltage: 3-6S LiPo(11.1V~22.2V)
- MCU: STM32F405RGT6 168MHz
- IMU: MPU6000 or BMI270
- OSD: Betaflight OSD &DJI HD OSD (UART6)
- 6 hardware UARTS (UART1,2,3,4,5,6,)
- Receiver: TBS/PPM/SBUS/IBUS/DSM
- Barometer: YES
- Buzzer Pad: YES
- CURR Pad: YES
- BEC 5V 2A & 10V 2A(Max 3A)
- Blackbox: 16MB
- Firmware: Betaflight /INAV SKYSTARS F405HD
- Mounting Holes: 20mm/M2 or M3
- Weight: 4.8g
1x Skystars RC F722 Mini HD Pro Flight Controller
8x Anti-vibration Grommets
1x Wiring Harness
We Also Recommend
Diatone Mamba MK4 F722 Mini F65_128K Mini ESC Flight Controller Stack (MPU6000)
Regular price $13799 $137.99
Diatone Mamba MK4 F722 Mini F55_128K Mini ESC Flight Controller Stack (MPU6000)
Regular price $11799 $117.99
Diatone Mamba MK4 F722 Mini F40_128K Mini ESC Flight Controller Stack (MPU6000)
Regular price $11099 $110.99