iFlight BOB57 Cinematic Long-Range and Freestyle 6 Inch DJI Drone

  • $599.99
    Unit price per 


Well-known FPV pilot and videographer Ellisvanjason and iFlight teamed up to craft a cinematic 6-inch drone that combines the advantages of both 5-inch and 7-inch drones.  The BOB57 retains both agility and flight time for the best of both worlds.


  • 6-inch drone re-engineered: This drone was specifically designed for 6-inch
  • H-shaped frame with a robust middle section for less props in view without sacrificing stiffness
  • XT60 front mount: Compare to other drones the mount sits in the front and gives more space on the back
  • Built-in BEC to directly power a GoPro (no battery needed)
  • Hybrid motor design: This motor is optimized for 6 inches. Can be used with bi- blades (efficiency) and tri-blades (agility & trust).
  • Antenna mount: Solid antenna mount for less ocillations when using long antennas
  • Long back bone: Enough space up to 3000mAh 6S batteries
  • Gladiator shell: Protection shell from dust and water droplets (shall be removed for max. flight time)
  • GPS: A high-end GPS is used to minimize the risk of failure during proximity flights
  • ESC: The drone consists iFlight's new ESCs with built-in spike absorber for more reliability
  • 9min flight time with 1800mAh 6S
  • 9+ with 3000mAh 6S Lipo or 4000mAh 6S Li-Ion
  • Get Ellisvanjason's tune on ellisvanjason.com


  • Upper(middle) plate thickness: 2.5mm
  • Bottom plate thickness: 1.5mm
  • Total Dimensions: 254*254mm
  • Bottom to top distance: 22mm
  • Geometry: H-shaped frame
  • Top plate thickness: 2mm
  • Ellisvanjason 2506 motors
  • Gemfan 6032 propellers
  • Arm Thickness: 6mm


FC //BLITZ F722 Flight Controller

  • Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
  • Smartaudio / IRC Tramp VTX protocol supported
  • Firmware target: IFLIGHT_BLITZ_F722
  • Motor outputs: 4x (SH1.0 connector)
  • Flash: 32MB (Blackbox flash)
  • I2C serial: SDA / SLA pads
  • Dimensions: 36.5*35 mm
  • Barometer: DPS310
  • OSD Chip: AT7456E
  • LED controller: Yes
  • MCU: STM32 F722
  • Beeper pad: Yes
  • Gyro: BMI270
  • Weight: 7.8g
  • UARTS: 6

Product Link

ESC // BLITZ E55 4-IN-1 2-6S 55A ESC

  • Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
  • Mounting Holes: 30.5*30.5mm/Φ4mm
  • Target: IFLIGHT_BLITZ_G2
  • Supports 2-6S Lipo input
  • Current sensor: Yes
  • Current Rate: 200
  • Constant: 55 Amps
  • Burst: 65 Amps
  • Weight: 15.3g
  • MCU: G071
  • BEC: No

Product Link

1x iFlight BOB57 Cinematic Long-Range and Freestyle 6 Inch DJI Drone
2x GEMFAN 6032 - CW propeller
2x 6032 CCW (Green)
2x GEMFAN 6032 - CW propeller
2x 6032 CCW (Black)
1x Albatross LHCP 5.8GHz SMA FPV Antenna 150mm
1x Albatross LHCP 5.8GHz SMA FPV Antenna 60mm
1x USB Type-C 5V Balance Plug Power Cable 55mm
2x iFlight Lipo Strap 20*250mm (Black)
1x Nebula Pro Vista HD System

We Also Recommend