NewBeeDrone Infinity300 AIO V2 Pro
NewBeeDrone Infinity 300 AIO V2 is the next generation of Infinity AIO Flight Controller. It is an upgrade to the original Infinity AIO V2, adding dual BMI270 gyros for better performance, reliability, and noise handling.
Any requests from the V1, we have them on the V2.
Our first-generation board was fully covered in heatsink and the components were sealed completely to provide better reliability and durability. Improving upon that, our V2 version is even better on weatherproofing and packed in all the requested features such as OSD Chips and more Uart ports.
The AIO is truly the next-level solution for flight controllers and ESCs. Based on our data from the Infinity AIO V1, not only was the AIO solution more compact but there were also fewer issues compared to stacks.
We have invested an immense amount of R&D time to optimize the hardware between high current and signal processing layout to make the board extremely compact and with no interference. Additionally, by sealing every component inside the aluminum heatsink which acts like a shield to protect from dust and other conditions, we maximize the physical toughness of the AIO stack.
Specifications:
- MCU: STM32F745VEH6
- Gyro: 2xBMI270
- Blackbox:16MB
- 6-Pin DJI FPV Air Unit Connector
- Micro USB Connector
- UART1 - SBUS on DJI Connector (RX only)
- UART2 - DJI Connector
- UART3 - Free
- UART7 - Free
- UART8 - Free
- 4x SMT32G071 BLHELI32 ESC MCU
- Continuedly Current 55A and 65A Burst ESC
- 3-6S Battery Input
- 12V 3A 30W Design for DJI FPV Air Unit
- 5x37mm with 30.5x30.5 Mounting Holes
- Weight: 22gr. without grommets
- Betaflight OSD support Analog build
- I2C_SCL I2C_SDA Ready
- Buzzer Ready
- LED Ready
- 5V 3A Power supply for external LED or GPS module
Please follow this solder instruction to complete the installation it will bring the best performance out of the InfinityAIO V2 PRO!
We highly recommend using the following filter preset. Check photo below
Recommended BLHeli_32 settings
Includes:
1x Newbeedrone Infinity 300 AIO V2 Pro
1x Infinity AIO V2 PRO to DJI Air Module Cable 100mm (Silicon wire)
1x Infinity AIO V2 PRO to DJI Air Module V2 Cable 100mm (Silicon wire)
2x Infinity AIO V2 PRO8 16Pin Cable 150mm (Teflon wire)
13x Nylon Lock Nut
5x Steel Screw M3x14
4x Grommets Short 4x Grommets Long
1x 470uf 35v Electrolytic Capacitor
1x XT60 Cable
