TBS Podracer AIO

  • $69.95
    Unit price per 

 

The Podracer AIO is a powerful whoop board designed in conjunction with Italian outfit, Zeezto make the ultimate whoop AIO.  This board is a designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact, and lightweight core for your build.

The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and long-range cruiser like the TBS Aureo.

Specifications:

FC Side

  • Mounting holes: 25.5×25.5 mm / M2 holes
  • Up to 6S input
  • 5V BEC up to 1.2A continuous
  • STM32F411 MCU (Support BetaFlight, EmuFlight)
  • MPU6000 Gyro/ACC
  • OSD chip Onboard (AT7456E)
  • 2 available UART
  • LC Filter for 5V VTX and Camera
  • Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
  • Support programmable LED like WS2812 etc
  • Built-in current sensor

ESC Side

  • Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
  • Input voltage: 2S-6S Lipo
  • Continuous current: 30A
  • Peak current: 35A
  • ESC firmware: BLHELI 32
  • PWM Frequency Range: 24KHz up to 96KHz

GPS Installation

Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. 
Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS.  

TBS Podracer AIO

How To

 1. Flash the board with Target: STM32F411

TBS Podracer AIO

2. Download the Config file [HERE]. Then load it on the board. 

3. Wire the GPS as shown 

TBS Podracer AIO

Includes:
1x TBS Podracer AIO >1x Capacitor
1x AWG Cables Set with Shrink Tubes
4x Mounting Gromets
1x XT60 (Male)
1x XT30 (Male)
1x Pinheaders set for TBS VTX and RX


    We Also Recommend