The next generation of FETtec's popular AIO KISS flight controller has arrived! Featuring the latest STM32 G4 MCU with math accelerator for the ultimate in flight performance, MPU6000 gyro, 2 dedicated BECs for 5V and 16V switchable power, DSHOT2400, 20x20 mounting holes, and 4-In-1 ESC with full sine wave control.
This new "N" version simply means there is no onboard analog OSD chip. Due to global shortages, the OSD chip was removed. This only affects analog systems, there are no other restrictions and you can use the full potential of this FC as you are used to. The use of external OSD boards and digital FPV systems still work fine.
The FETtec OSD Board is perfect for analog users still wanting OSD.
Specifications:
FLIGHT CONTROLLER
- Latest STM32G4 Processor
- 170Mhz + Math accelerator
- MPU6000
- Supply voltage 12-25V (3S-6S Lipo voltage)
- 2x dedicated onboard
- 5V BEC for VTX (max. 600mA each)
- 5V BEC for RX 5V/16V BEC for VTX (switchable and real Pit*)
- 1x 8 pin connector for solder free VTX, cam connection and OSD or digital systems
- VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3
- 2x 4 pin connector for receiver and VTX
- Signal, telemetry, 5V, gnd
- Gnd, 5V, TX1, RX1
- 5 UART serials
- UART 1 free
- UART 2 used for Receiver
- UART 3 free
- UART 4 free
- UART 5 used for ESCs / TLM / Onewire
- Solder pad for RGB LEDs
- Supported ESC protocols
- PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
- KISS FC firmware
*Real Pit-Mode: A power supply pin which is remotely switchable
ESC
- Active current limiting @ 35A
- Input voltage: 3s-6s
- High-quality 40V MOSFETs
- STM32G071 @ 64MHz up to 128 kHz Motor PWM
- Full sine wave control
- Automatic input signal detection
- PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
- FETtec ESC firmware
Connector type: JST-SH-1mm
Dimensions:
- Maximum outside dimensions: 30 x 37.5mm
- Mounting hole arrangement: 20 x 20mm with M2 mounting holes (expandable to M3)
- Overall Height: 7.9mm
- Weight: 8.9g
Software:
Kiss Firmware - Software update via FETtec Configurator
FETtec ESCs Firmware - Software update via FETtec Configurator
Includes:
1x FETtec KISS AIO G4 - N Flight Controller w/ 4-In-1 ESC
1x Capacitor 50V 470uF
2x 4 pin cable with JST connector on one side
1x 8 pin cable with JST connector on one side
Standoffs